Implementing issues - iGrade alone
Troubleshooting performance.
Symptoms:Implement responds too slowly to changes in gradeBlade fails to hold gradeUnexpected shi...
Implementing issues with iGrade (will occur without T3RRA connected)
NOTE: There will be situations where your dealer may ask you to capture a StarFire message log fo...
Bi-Directional error in iGrade.
Symptoms:The implement consistently cuts when heading in one direction and fills in the other dir...
Blade continuously loads on one side.
Symptoms:System is grading low on one side.Cause:There are multiple possible causes for this.iGra...
Poor “on grade” performance.
Symptoms:Blade Struggling to hold grade.Cause:There are multiple possible causes for this issue.I...
Engaging auto causes the scraper to raise into the air.
Symptoms:Operator engages scraper into detent (auto mode) and the scraper extends to full stroke ...
Scraper is “washboarding”.
Symptoms: Scraper causes a washboard effect. A-If washboarding is close together, flow rate i...
Implement blade moves to an extreme position when placed in Auto.
Symptoms: When placing the machine in Auto, the implement’s blade dives deep, climbs to full hei...
Blade not staying on grade & acting inconsistently.
Symptoms:Blade is acting erratically.Blade height is on grade for a while but then moves down a f...
The implement blade does not seem to follow the design surface.
Symptoms:The blade is moving up and down in ways that indicate that it is being successfully cont...
Implement blade is intermittently jumping up or attempting to deep dive.
Symptoms: Work is progressing normally but occasionally the blade will suddenly rise up, or att...
Erratic performance during drain implementation.
Symptoms:Implement moving erratically while implementing drains.Implement moving erratically whil...
iGrade is indicating that Remote Commands are not being received from T3RRA software or indicating ‘No Surface Defined’.
Symptoms: The iGrade display is showing a “No Remote Commands” error message, and iGrade is not ...
Error from grade values do not match on iGrade and T3RRA software.
Symptoms:When stationary, or at very low speeds, the value for error from grade reads 0 on the iG...
User cannot turn “Grade On” with iGrade 2.
Symptoms: You have iGrade setup for remote Control. You have a field design in T3RRA Cutta with ...
Poor as-applied coverage.
Symptoms:The as-applied map looks blotchy, streaky, incomplete, or otherwise incorrect.Cause:The ...