8. Implementation screen
The Implementation Screen
When you begin implementation of your design, the display will show a cut/fill map as well as too...
1. Setting Zero
Important: Before work can begin, the system must be “zeroed”. Both the T3RRA software and iGra...
2. Cross-slope Adjustment
T3RRA software is capable of sending cross slope commands to iGrade™. It can operate automaticall...
3. Vertical blade shift
The blade shift buttons in T3RRA Cutta and T3RRA Ditch serve to manually shift the height of the ...
4. Cut/Fill information display
In the upper left corner of the screen more information is shown about current ground height, des...
5. Progress bars
In the upper right of the screen are 2 percentage counters that show the amount completed. These ...
6. On-grade indicator
At the left side of the map screen there is a grouping of up/down chevrons that show the current ...
7. Blade and Tractor Indicators
When you are implementing a design, each implement will appear as a triangle pointing towards you...
8. Map Display
When implementing the display will show a cut/fill map by default. The Cut/fill map will be displ...
9. Drain Profile
When implementing a drain you are able to bring up a display on the screen that shows the profile...