Recently Updated Pages
6.6 | Survey Point edit controls
During surveying and surfacing, there are various different ways to edit/remove drain and survey ...
4.5 | Choose Mode/Terrain/Layer
Mode 2D View displays the map as a 2D aerial view by default. 3D View shows terrain as small hill...
1.8 | Installing T3RRA Software
T3RRA software is typically installed and configured by your authorised T3RRA dealer as part of s...
7.9 | Offset Design
Select the 'Offset' button to raise or lower the surface height of a field or region. This can ...
7.9 | Fendt 900 SCR/S4
Applicable to: Supported Fendt 900 SCR/S4 tractors using the COMMAND Fendt SCR/S4/MT valve interf...
7.8 | Fendt 800 SCR/S4
Applicable to: Supported Fendt 800 SCR/S4 tractors using the COMMAND Fendt SCR/S4/MT valve interf...
7.7 | Fendt ONE — 900 Gen 6/7 & 1000 Gen 2/3
Applicable to: Supported Fendt 900 Gen 6/7 and Fendt 1000 Gen 2/3 tractors using the COMMAND Fend...
7.5 | Versatile — Analog Scraper Control
Applicable to: Supported Versatile L4WD and DeltaTrack tractors fitted with the 6-pin C920 laser/...
7.4 | CNH Pre AFS Connect / PLM Intelligence
Applicable to: Case IH / New Holland tractors prior to AFS Connect or PLM Intelligence systems. C...
7.3 | CNH Direct Connect (AFS Connect / PLM Intelligence)
Applicable to: Case IH / New Holland tractors with AFS Connect or PLM Intelligence systems. Conne...
7.2 | John Deere Legacy (Analog)
Applicable to: John Deere tractors with analog SCV control (typically pre-2005 models). Connectio...
7.1 | Modern John Deere (CANBUS)
Applicable to: John Deere tractors with CANBUS-based SCV control (typically 2005+ models). Connec...
6.4 | Tractor CAN Connection (Optional)
Overview COMMAND can be connected to a 250 or 500kbps Tractor CANBUS if present, allowing the ECU...
2.3 | GNSS Receiver & IMU Compatibility
The requirements below outline the important components and considerations for using a GNSS recei...
7.14 | Levee Design
'Levees' allows you to create repeating or singular levees at set elevations. Levees can be added...
7.12 | Pattern Drain Design
This design tool allows for simple design of many parallel drains at once. Watch the Pattern Dra...
7.8 | Smooth Design
Select the 'Smooth' button to create a more regular surface with fewer and more gradual hummocks ...
7.1 | Design
Measure twice, cut once. It’s an old maxim but a good one. You can do as many designs as you wan...
5.7 | Survey Guidelines
No matter what type of surveying you are doing you are able to implement guidance lines on the su...
4.2 | Common tools found in the Wizard
Several buttons appear on multiple wizard pages. The reference below shows the tools and any limi...