Recently Updated Pages
9.2 | Honeywell TARS-B IMU (T3H-E003)
Applicable to:Systems where the GNSS receiver does not provide terrain compensation and/or Cross-...
9.1 | John Deere StarFire TCM (3000, 6000, 7000, 7500)
Applicable to:John Deere StarFire 3000, 6000, 7000 & 7500 receivers with integrated Terrain Compe...
7.1 | Modern John Deere (CANBUS)
Applicable to:John Deere tractors with CANBUS-based SCV control (typically 2005+ models). Connec...
6.3 | Joystick Connection (Optional)
Overview In most cases the manual control of hydraulic functions are already available (e.g. when...
6.1 | Arm/Engage Switch Installation
The COMMAND Arm/Engage Switch is used by the operator to both Arm/Disarm ECU control outputs, and...
5.3 | Powering COMMAND
Select the appropriate power supply method based on ECU mounting location. Cab-Mounted ECU COMMAN...
4.4 | ISOBUS Requirements
COMMAND does not explicitly require the tractor to be fitted with an ISOBUS system to operate; h...
4.2 | Tractor Requirements
Tractor Requirements COMMAND's tractor requirements are as follows: Provide a suitable power sup...
4.1 | Overview
All requirements in this section must be confirmed before installing the COMMAND system. Failure...
2.1 | System Architecture
Theory of Operation COMMAND is an electronic control system designed by T3RRA consisting of an El...
1.5 | Important Safety Information
WARNING:The COMMAND system can automatically control hydraulic movement without operator input.En...
10.6 | CANBUS / Communication Issues
Issue Possible Cause Recommended Action ISOBUS communication unavailable ISOBUS harness d...
10.5 | IMU & Terrain Compensation Issues
Issue Possible Cause Recommended Action Cross-slope compensation not operating correctly ...
10.3 | Hydraulic Control Issues
Issue Possible Cause Recommended Action No hydraulic movement Valve harness disconnected ...
1.4 | Important User Information
The COMMAND system must only be installed and operated by individuals trained in its functional a...
2.5 | System Components
A Level COMMAND system consists of multiple hardware and software components depending on machine...
2.4 | Hydraulic & Vehicle Interfaces
The COMMAND hardware platform supports multiple hydraulic and vehicle interface methods depending...
2.3 | Positioning & Sensor Requirements
Level COMMAND uses GNSS positioning data, machine geometry information, and implement orientation...
1.5 | Operator Responsibilities
System Usage The COMMAND hardware platform and Level COMMAND operating environment must only be i...
1.3 | Intended Use
Level COMMAND is intended for use on supported construction, landforming, and earthmoving machine...