Recently Updated Pages
Regular Smoothing
Regular smoothing applies an averaging filter to the surface of the field to remove bumps and dip...
Save Project
Saving a project allows you to return to it at a later time and ensures that you have a copy of t...
Settings
Settings can be found at the top of the screen when not viewing a map or exporting. This page h...
No GPS signal is being received from iGrade.
Symptoms: Tractor position icon not appearing on map-screens. ‘GPS info’ button in the bottom r...
Loading Projects
The ‘Load proj.’ button is used to load any saved T3RRA projects. T3RRA projects can be loaded in...
Import page
When you have collected your elevation or design data with an external tool, importing is the way...
Export to *.gps control file is too far from benchmark
Symptoms: When the .gps file is loaded into the display, the system complains that the field is ...
Offset Design
Select the 'Offset' button to raise or lower the surface height of a field or region. This ...
Offset Design
Select the 'Offset' button to raise or lower the surface height of a field or region. This can ...
Levee Creation Parameters
'Start Elevation' will be populated automatically. You can also choose the ‘Start Elevation’ by m...
Understanding the relationship between the "As-applied" surface and the Dynamic Blade Limit.
The Dynamic Blade Limit (See the section of “Static Blade Limit” in the Limits Tab for disambigua...
Starting Implementation
T3RRA Software implementation startup instructions for UCC1 1. Drive to a zero cut/fill area and ...
Understanding how "As-applied" works
When moving earth there are three states:What you started with.What you intended to do.What you a...
The Implementation Screen
When you begin implementation of your design, the display will show a cut/fill map as well as too...
1. Setting Zero
Important: Before work can begin, the system must be “zeroed”. Both the T3RRA software and iGra...
2. Cross-slope Adjustment
T3RRA software is capable of sending cross slope commands to iGrade™. It can operate automaticall...
3. Vertical blade shift
The blade shift buttons in T3RRA Cutta and T3RRA Ditch serve to manually shift the height of the ...
4. Cut/Fill information display
In the upper left corner of the screen more information is shown about current ground height, des...
5. Progress bars
In the upper right of the screen are 2 percentage counters that show the amount completed. These ...
6. On-grade indicator
At the left side of the map screen there is a grouping of up/down chevrons that show the current ...