Recently Updated Pages
1.2 | About Our Software
Mark Twain and Will Rogers shared the sentiment, “Buy land, they’re not making it anymore”. We ca...
1.1 | Important Notices
Important: Please read this before using any of our software products. T3RRA Operators Manual © 2...
8.10 | Drain Profile
Displaying the drain profile When implementing a drain you are able to bring up a display on the ...
8.9 | Map Display
When implementing the display will show a cut/fill map by default. The Cut/fill map will be displ...
8.8 | Blade and Tractor Indicators
GPS status indicators When you are implementing a design, each implement will appear as a triangl...
8.1 | The Implementation Screen
When you begin implementation of your design, the display will show a cut/fill map as well as too...
8.7 | On-grade indicator
At the left side of the map screen there is a grouping of up/down chevrons that show the current ...
8.6 | Progress bars
In the upper right of the screen are 2 percentage counters that show the amount completed. These ...
8.5 | Cut/Fill information display
In the upper left corner of the screen more information is shown about current ground height, des...
8.4 | Vertical blade shift
The blade shift buttons in T3RRA Cutta and T3RRA Ditch serve to manually shift the height of the ...
8.3 | Cross-slope Adjustment
T3RRA software is capable of sending cross slope commands to iGrade™. It can operate automaticall...
8.2 | Setting Zero
Important: Before work can begin, the system must be “zeroed”. Both the T3RRA software and iGrade...
7.17 | Terrace Design
'Terraces' allows you to create Guidance curves to mark terraces for erosion control. When you fi...
7.16 | Completing your design
Once satisfied with your design surface and/or drain. 1. Select the 'Return' button. (Top right ...
7.15 | Exporting Guidance lines from T3RRA and importing into AutoTrac.
Remember that guidance lines are only available for Drains and Levees. Should you wish to export ...
7.13 | Drain Design
Drain paths can be created by: Surveying them in the 'Collection' wizard step Importing them Usin...
7.11 | Auto-Drains Design
You can use Auto-Drains to automatically generate drain paths for wet areas in your field. It wil...
7.10 | Drain Design Tools
When designing drains, there are several aspects that you will find that are across all the diffe...
7.7 | Multi-fit Design
'Multi-fit' creates an optimized non-linear surface with slopes between the entered minimum and m...
7.6 | Best-fit Design
Select the 'Best-fit' button to create a plane of best fit for a field. Video: Watch the Best-fi...