Skip to main content

3.4 | Limits Tab

Blade shift increment

Blade Shift Increment sets the height adjustment applied by the up/down elevation adjustment buttons in the implementation wizard step.

Limits tab with Blade Shift Increment, Static Blade Limit and Dynamic Blade Limit controls; As Applied is required
Limits tab with Blade Shift Increment, Static Blade Limit and Dynamic Blade Limit controls; As Applied is required

Static blade limit

Static Blade Limit temporarily changes target design heights by a specified amount. At 50%, target cut and fill heights become 50% of the design values. It can also overfill a design by a percentage to allow for soil to sink over time: at 110%, a 100mm fill becomes 110mm to allow for future compaction.

Build banks, roads or mounds in gradual steps to allow even compaction of dirt.

Ignore cuts is useful when gradually building a mound. Use the vertical nudge to lower the design surface below the current surface, then slowly nudge it upwards so filling begins at the apex and proceeds outwards. In this case, avoid cutting where the nudged mound design is below the original surface. NOTE: Ignore cuts can be activated even when Static Blade Limit is set to “None”.

Set the static blade limit amount on the implementation screen.

Methods for progressively adding layers of dirt to a fill area

Static Blade Limit by Percent: dashed curved layers progressing from the original surface towards the mound design
Static Blade Limit by Percent — Static Blade Limit by Percent: dashed curved layers progressing from the original surface towards the mound design
Static Blade Limit by Absolute Value: horizontal dashed fill layers beneath a curved mound design
Static Blade Limit By Absolute Value — Static Blade Limit by Absolute Value: horizontal dashed fill layers beneath a curved mound design
Vertical blade offset with Ignore cuts: dashed mound profiles rising from below the original surface
Combination of vertical blade offset + Ignore cuts — Vertical blade offset with Ignore cuts: dashed mound profiles rising from below the original surface

Dynamic blade limit

Dynamic Blade Limit sets the increment the blade moves per pass of cut or fill. It allows progressive cutting to a total depth without over cutting on an individual pass.

Limits tab showing Enable cut limit, Enable fill limit, Max Cut and Max Fill, with the As Applied requirement
Limits tab showing Enable cut limit, Enable fill limit, Max Cut and Max Fill, with the As Applied requirement

Take cuts in bite-size chunks to avoid overloading the machine.

Apply Dynamic Blade Limit to cuts only, fills only, or both.

Dynamic Blade Limit uses as-applied functionality to track blade heights from previous passes and set the current blade height. It does not operate unless as-applied functionality is activated. For more, see Understanding the relationship between the “As-applied” surface and the Dynamic Blade Limit.

Dynamic blade limit diagram showing Original, Pass 1, Pass 2 and Pass 3 descending towards Design
Dynamic blade limit diagram showing Original, Pass 1, Pass 2 and Pass 3 descending towards Design