Skip to main content

4.6 | GPS Data

GPS information button displaying longitude, latitude and heading beside a position icon.

The GPS information button is in the lower-right corner of the screen. It shows your current latitude, longitude and heading.

TIP: Right-click (press and hold) the GPS information button to open a context menu with an option to display coordinates in UTM format.

Press the GPS information button to open the GPS Info window for more detailed GPS information.

GPS Info window with serial port parameters, Warning/Error Configuration, Current and Raw GPS Data tabs, and a receiver data row.

The GPS Info window contains the following information:

  • Serial port parameters : displays the current settings for the com port and baud rate that is being used. There are flashing arrows which indicate that the software is sending and receiving information.
  • Warning Thresholds : used to set limits for certain parameters. When these thresholds are being approached the borders of the screen will flash orange, once any of the thresholds have been exceeded or connection to GPS is cut the borders of the screen will flash red.
  • Output : shows all the GPS information currently being received.

Serial port parameters

Com port: The adapter assigns the Com port #. The drop-down box lists all available com ports. Select the serial port physically connected by cable to the iGrade™ Application Controller. Windows Device Manager provides diagnostics for the current serial ports; you can open it using the button at the bottom left of Settings > GPS.

Serial port parameters panel with Com port COM1 and Baud rate 38400 drop-downs and send/receive arrows.

Settings window with the GPS tab selected, serial and warning parameters, and the Open Device Manager button at bottom left.

Baud rate: This is the speed of communication with iGrade™. It must match the iGrade™ settings, or T3RRA software cannot communicate with iGrade™. For iGrade v1, the recommended baud rate is 38400. For iGrade™ v2, the recommended baud rate is 115200, with NMEA Message Type set to “All”.

Warning Thresholds

Idle timeout: An error warning appears if no GPS messages are received within this time period.

Warning/Error Configuration panel with Idle Timeout, RTK Timeout, Max VDOP and Min Satellite Count fields.

RTK Timeout: This monitors the time since the last good RTK correction packet. It should not normally be set above 10-20sec.

Max VDOP: Vertical Dilution of Precision measures altitude accuracy. Keep this value as low as possible for the most accurate implementation, but setting it lower than 2 may interrupt use of T3RRA software.

Min Satellite Count: Sets how few satellites the GPS needs to see before a warning appears.

Output

Current and Raw GPS Data tabs above a receiver data table with latitude, longitude, altitude, satellite count, fix and GPS time columns.

FieldMeaning
Current & Raw GPS Data:Current shows the receiver’s current position data. Raw GPS Data shows all incoming messages.
Lat & Lon:Your current location coordinates (latitude and longitude).
Altitude:Your current height above sea level, displayed in the chosen measurement format.
Num Sats:The number of satellites currently tracked by your GPS. It is linked to Min Satellite Count in Warning thresholds: an error appears if the count drops below that setting.
Fix:The type of position solution calculated.
Time:The current GPS time.
Last Correction:The time since the last differential correction message from the base station. Keep it as low as possible for the most accurate readings. It is linked to RTK Timeout in Warning thresholds: an error appears if it exceeds that limit.
VDOP:Vertical Dilution of Precision. An error appears if this number exceeds Max VDOP in warning thresholds.