4 | COMMAND Commissioning and Configuration
4.1 | Connecting to the COMMAND ECU
To access COMMAND ECU settings, enter the Settings menu and select the COMMAND tab. The Machin...
4.2 | Checking for Software & Firmware Updates
Before proceeding with machine configuration and calibration, ensure both the T3RRA Software appl...
4.3 | Selecting A Machine Profile
Profile The profile is used to select the type of implement being used, for detailed information ...
4.4 | Configuring GNSS
The Inputs/Offsets page is used for selection of input sensors, such as GNSS receivers for height...
4.5 | Configuring Valve Outputs
The Valve Configs page is used to set up the control output interface for each control function....
3.6 | Valve Threshold Calibration
Valve Threshold Calibration establishes the minimum and maximum hydraulic outputs used by Automat...
4.7 | Cylinder Ratio Calibration
Overview Cylinder Ratio Calibration compensates for differences in implement movement speeds betw...
4.8 | Tuning Automatic Implement Control
The purpose of tuning is to achieve stable, accurate Automatic Control that follows the design su...
4.9 | Validating System Operation
Status Validation Checks Item Expected Result ECU Status Connected and operating normally GNSS St...