3 | Dealer Installation & Commissioning
The purpose of dealer commissioning is to verify that all machine sensors, hydraulic outputs, GNSS receivers and automatic control functions are operating correctly, and that the machine is ready for operator use.
3.1 | Connecting to the COMMAND ECU
To access COMMAND ECU settings from the Apply View, press "More" at the right side of the screen,...
3.2 | Checking for Software & Firmware Updates
Before proceeding with machine configuration and calibration, ensure both the Level COMMAND appli...
3.3 | Selecting A Machine Profile
Profile The profile is used to select the type of implement being used, for detailed information...
3.4 | Configuring GNSS
The Inputs/Offsets page is used for selection of input sensors, such as GNSS receivers for heigh...
3.5 | Configuring Valve Outputs
The Valve Configs page is used to set up the control output interface for each control function....
3.6 | Valve Threshold Calibration
Valve Threshold Calibration establishes the minimum and maximum hydraulic outputs used by Automat...
3.7 | Cylinder Ratio Calibration
Overview Cylinder Ratio Calibration compensates for differences in implement movement speeds bet...
3.8 | Tuning Automatic Implement Control
The purpose of tuning is to achieve stable, accurate Automatic Control that follows the design su...
3.9 | Validating System Operation
Status Validation Checks ItemExpected ResultECU StatusConnected and operating normallyGNSS Status...