Skip to main content

8.1 | Modern NMEA 2000 (Case, New Holland, Trimble)

This section covers connection of Novatel-based GNSS receivers using a 12-pin Deutsch interface.

Applicable to receivers including:
Case IH - Vector Pro
New Holland - PLM Cygnus
Trimble / PTx Trimble - AG-372, AG-392, NAV-900, NAV-960
Steyr - S-Guide

image.png

Parts Required

  • CNH 115-7100-009/10 - Front Extension Harness or JD BPF11284 - Front Extension Harness
  • CNH 115-7100-005 - Cable Adapter Terminator Gen I ISOBUS or JD PF81137 - Implement Pigtail Terminator Wiring Harness
  • T3H-G002 - COMMAND Impl Adapter - NAV-900
  • T3H-S001 - COMMAND Impl Adapter – Stub Junction

Connection Process

1. Connect the Front Extension Harness to the ISOBUS breakaway connection.

image.png

2. Route along the implement, allowing slack at pivot points and avoiding snag hazards.

3. Connect the T3H-S001 adapter to the Front Extension Harness.

image.pngAGV_vUfb18F8k_oebTBPqwfo9XiNBZNwKnM3oAVQCWqCnu81_ej-90MsO88UGKN3PqpReGufqT-IkPoI1yc2PhvecRKLpNyTiBilDY77gJACZvIxS1F6s2OWMRFvOABjb9rzPqRAgXX6yw=s2048?key=pKn9UTVcy7kVo7f76IQZkQ

4. Connect the Implement Pigtail Terminator to the T3H-S001 adapter and secure the terminator to the implement receiver wiring harness.

image.png

5. Connect the T3H-G002 adapter to the T3H-S001 adapter.

image.png

6. Connect the T3H-G002 adapter to the appropriate GNSS receiver port.

7. If using NMEA 0183 Serial, also connect the NMEA extension harness to the T3H-G002, then connect the other end to the T3H-C002 ECU breakout harness.

Verify:
- Receiver powers on

Back to top