Recently Updated Pages
1.7 | Terminology & Definitions
Armed Automatic control is enabled and ready to assume implement control when engagement conditio...
1.6 | Important Safety Information
General Safety Guidelines Read and Understand Instructions Operators must read this manual in ful...
2.2 | Supported Implement Types
COMMAND machine profiles are used to store all configuration settings for that particular impleme...
1.2 | About This Manual
This manual provides instructions for the installation, configuration, and operation of T3RRA's C...
1.3 | Important Notices
COMMAND Installation & Operators Manual © 2026 T3RRA Pty Ltd Notice of Rights No part of this pub...
1.1 | Title
Installation & Operators Manual 2026
Get Remote Support
When the manual isn’t quite enough, and you just need some flesh and blood assistance, we’ve got ...
Show Depressions
This tool displays all depressions in the visible surfaces. The overlay layer shows the dep...
No GPS signal is being received from iGrade.
Symptoms: Tractor position icon not appearing on map-screens. ‘GPS info’ button in the bottom r...
Export to *.gps control file is too far from benchmark
Symptoms: When the .gps file is loaded into the display, the system complains that the field is ...
Levee Creation Parameters
'Start Elevation' will be populated automatically. You can also choose the ‘Start Elevation’ by m...
My drains have ‘bumps’ in them that weren’t present when I designed them.
Symptoms: A drain line was created with a set profile but when implementing it seems to have une...
‘As-Applied’ not updating correctly
Symptoms: When on the implementation screen, the “As-Applied” Cut/Fill map was not updating as p...
Project has moved N/S or E/W.
Symptoms: When you return to an existing job the map is no longer aligned with the position of t...
My drain design is no longer present in the ‘Apply’ wizard step.
Symptoms: The Cut/fill map of drain surface in the Apply step is representing no cut and no fill...
User cannot turn “Grade On” with iGrade 2.
Symptoms: You have iGrade setup for remote Control. You have a field design in T3RRA Cutta with ...
Tractor position icon does not adjust when you zero against a benchmark.
Symptoms: You are parked over a physical benchmark and want to adjust the map location so that t...
Implement blade is intermittently jumping up or attempting to deep dive.
Symptoms: Work is progressing normally but occasionally the blade will suddenly rise up, or att...
iGrade is indicating that Remote Commands are not being received from T3RRA software or indicating ‘No Surface Defined’.
Symptoms: The iGrade display is showing a “No Remote Commands” error message, and iGrade is not ...
Blade not staying on grade & acting inconsistently.
Symptoms:Blade is acting erratically.Blade height is on grade for a while but then moves down a f...