Advanced Search
Search Results
83 total results found
Poor as-applied coverage.
Symptoms:The as-applied map looks blotchy, streaky, incomplete, or otherwise incorrect.Cause:The as-applied map will only be correct for a single machine working in a field. If part of the field is done by another machine this information will not be relayed t...
Bi-Directional error in T3RRA.
Symptoms:The implement consistently cuts when heading in one direction and fills in the other direction. Final grade is never achieved. If T3RRA software is halted and iGrade is run in ‘Plane Control’ only the problem goes away.Cause: There is a slight time la...
Tractor position icon is far above or below the surface.
Symptoms:When implementing the position icon appears to be a long way above or below the surface (the tractor icon will normally rise to surface height if it is below the surface, but as-applied cuts will be far too deep).Cause:The zero value has been incorrec...
Tractor position icon does not adjust when you zero against a benchmark.
Symptoms: You are parked over a physical benchmark and want to adjust the map location so that the related on-screen benchmark icon matches the location on the tractor icon. However when you perform the “Zero using a marker” action nothing changes. The icons ...
Map icon on the T3RRA software screen lags behind the actual field position.
Symptoms:The screen update appears to be “laggy”. When you turn a corner and are back on a straight path you may see that the position icon on the screen is still turning the corner.Cause:This normally indicates that the software is having to do a lot of calcu...
‘As-Applied’ not updating correctly
Symptoms: When on the implementation screen, the “As-Applied” Cut/Fill map was not updating as per pass on the field. Cause: Ensure the "Implement Width" is entered and they have "As -Applied" enabled. Solution: If "Implement Width" is entered and "A...
Project has moved N/S or E/W.
Symptoms: When you return to an existing job the map is no longer aligned with the position of the tractor. The project surface has moved North/South or East/West. Cause: Previously entered offsets have been cleared under the Machine tab in settings. ...
My drain design is no longer present in the ‘Apply’ wizard step.
Symptoms: The Cut/fill map of drain surface in the Apply step is representing no cut and no fill. The profile view in the Apply step of the drain is a solid red line. Causes: A drain design was created for one or more of the multiple drains in one projec...
My drains have ‘bumps’ in them that weren’t present when I designed them.
Symptoms: A drain line was created with a set profile but when implementing it seems to have unexpected deviations. Cause: Multiple drains were designed and have overlapping sections. The profile of a drain gets ‘overwritten’ by the profile of a subseque...
Implement is offset a large amount after 'zeroing'
Symptom:Your implement is offset by a large amount when you zero before implementing.Possible causes:A value has been entered into the Blade clearance causing the zeroed amount to be higher than normal.Solutions:
No GPS signal is being received from iGrade.
Symptoms: Tractor position icon not appearing on map-screens. ‘GPS info’ button in the bottom right of map-screens is red. In the ‘Settings’ window there are no characters streaming into the ‘Serial port raw data’ window in the ‘GPS Port Settings’ tab. S...