Search Results

To access COMMAND ECU settings from the Apply View, press "More" at the right side of the screen, then "COMMAND Settings". The COMMAND Settings Overview page shows each page related to operation of the ECU. The Machine page is used to setup the connection be...

Before proceeding with machine configuration and calibration, ensure both the Level COMMAND application and the COMMAND ECU are updated to the latest available versions. Recommended Procedure Connect to the COMMAND ECU successfully as performed in section 3.1...

Valve Threshold Calibration establishes the minimum and maximum hydraulic outputs used by Automatic Control. Correct calibration ensures the implement can move smoothly for small corrections while still achieving full operating speed when required. Access the ...

Overview Cylinder Ratio Calibration compensates for differences in implement movement speeds between opposing control directions. Hydraulic systems rarely move at identical speeds in both directions. Differences in cylinder geometry, implement weight, hydrauli...

The purpose of tuning is to achieve stable, accurate Automatic Control that follows the design surface smoothly without excessive lag or oscillation. The Tuning page provides the controls and feedback required to optimise control performance. To find the tunin...

The Layout page allows the Apply View to be customised to suit different machines, grading tasks and operator preferences. To open the Layout page from the Apply View, press: More → Layout Choosing a Layout Three layout modes are available: Triple – Display...

The widgets along the bottom of the Apply View provide quick access to important machine, GNSS and grading information while operating Level COMMAND. Almost every widget can be replaced with another value, allowing the display to be customised to suit differen...

Plane Projects allow simple design surfaces to be created without first surveying the entire work area. They are commonly used for creating flat pads, graded surfaces, drain batters and other simple earthworks. Each Plane Project can contain up to four individ...

Pre-designed Projects allow Level COMMAND to grade using surfaces that have been created outside the application. These projects are typically prepared by a dealer, surveyor or designer before being transferred to the machine. Compared with Plane Projects, imp...

Level COMMAND allows important locations within a project to be recorded using Markers and Benchmarks. Although both are created using the same tool, they serve different purposes during surveying, grading and future site visits. Markers provide useful refere...

Blade Control Modes determine how Level COMMAND interprets the design surface beneath the blade when calculating the required target position. Different grading situations benefit from different control strategies. Some modes prioritise accurately following th...

The Units page allows you to select the measurement units used throughout Level COMMAND. The available unit categories are: Length / Height – Millimetres, Centimetres, Metres, Inches, or Feet. Volume – Cubic Metres, Cubic Yards, or Cubic Feet. Area – Hectare...

The Language & Accessibility page allows you to customise the interface language and on-screen keyboard behaviour to suit your device and operating preferences. Language Selects the display language used throughout Level COMMAND. For the best experience, res...

The Licensing page is used to activate Level COMMAND and register the software for normal operation. To open the Licensing page, press More → License. A valid licence is required for normal operation. If Level COMMAND has not been activated, a Demo Mode banne...

The Support & Error Reporting tools allow operators and dealers to receive remote assistance and provide feedback directly to T3RRA. To access the Error Reporter, press More → Report. An internet connection is required for Remote Support and sending reports. ...

The Diagnostics & Advanced page provides access to advanced application settings, diagnostic tools and project information. To open this page, press More → Diagnostics / Advanced. Most options on this page are intended for dealers, advanced users or troublesh...

The Valve Configs page is used to set up the control output interface for each control function. Appropriate signals of that interface type are then generated when automatic or manually controlling the implement. External joystick inputs are also configured o...

The Inputs/Offsets page is used for selection of input sensors, such as GNSS receivers for height control or Inertial Measurement Units (IMU) for terrain compensation and Tilt / X-slope control. GNSS Input Configuration Pre-configuration Before configuring Le...