3.6 | Calibrate Cylinder Ratios

Cylinder calibration allows you to control the relative speed of your implement's extend/retract motion. We recommend calibrating this with an implement about half-loaded with soil to ensure the values reflect working conditions. To calibrate, fully retract your implement's relevant hydraulics, then time how long it takes to fully extend using the upper on-screen stopwatch. Simply tap the button to start timing, and tap again to stop timing. Once complete, time a full retraction using the lower on-screen stopwatch the same way. Once you have timed both to satisfaction, tap the Calc button to determine the calibration ratio. You can also tap on the ratio to edit it directly in case adjustments are desired. If you have cross slope control, you can calibrate it too, by selecting it in the bottom right. An example of calibrated height and cross slope hydraulics are shown below.