Skip to main content

3.1 | Connecting to the COMMAND ECU

The Machine page is used to setup the connection between Level COMMAND software and the COMMAND ECU in addition to selecting the machine profile being used. To get to this page, first go to the COMMAND Settings page and click the top left 'Machine' button.

image.png

ECU

CommsSerial Connection

Begin by connecting to the COMMAND ECU using the Comms tab. PickSelect the correct COM port your ECU is connected to from the list, or click the 'Scan ports' button to search for COMMAND data among all serial ports present.

image.png

If the scan was successful, clicking on Connect will establish communications with ourthe COMMAND ECU. A successful connection is indicated by:

    Port Connection Status = Connected, ECU Connection Status = Connected, ECU Authentication Status = Success

    If Level COMMAND fails to connect to the ECU andover readthe allchosen itsCOM port, a warning will be displayed as shown below. 

    If connection fails:

      Verify ECU power Confirm the correct COM port is selected Check USB or serial connections

      image.png

      If the ECU is detected successfully, click Connect.

      Level COMMAND will:

        Establish communication with the ECU Read stored parameters.parameters Load the current machine configuration

        Once that'sconnected, complete, you'll be readyproceed to setProfile up your profile in the next section by tapping the 'Profile' button in the lower right.

        image.pngSetup.

        Back to top