Skip to main content

8.3 | Modern Case IH / New Holland / Trimble

This section covers connection of Novatel-based GNSS receivers using a 12-pin Deutsch interface.

Applicable to:

    Case IH - Vector Pro0 Pro
    New Holland - PLM Cygnus
    Trimble - AG-372, AG-392, NAV-900
    Steyr - S-Guide

    VectorPro.pngimage.pngimage.pngimage.png

    Parts Required

    • BPF11284 - Front Extension Harness (10m)
    • PF81137 - Implement Pigtail Terminator Wiring Harness
    • T3H-G002 - COMMAND Impl Adapter - NAV-900
    • T3H-S001 - COMMAND Impl Adapter – Stub Junction
    • Optional - T3H-G001 / T3H-G007 - COMMAND NMEA Extension Harness
      • Only required if using NMEA 0183 Serial for GNSS data.

    Connection Process

    1. Connect the John Deere Front Extension Harness to the ISOBUS breakaway connection.

    2. Route along the hosing/implement making sure to leave some slack at pivot points and paying close attention to any objects that could get caught on the harnessing.

    image.png

    3. Connect the T3H-S001 adapter to the Front Extension Harness.

    image.pngAGV_vUfb18F8k_oebTBPqwfo9XiNBZNwKnM3oAVQCWqCnu81_ej-90MsO88UGKN3PqpReGufqT-IkPoI1yc2PhvecRKLpNyTiBilDY77gJACZvIxS1F6s2OWMRFvOABjb9rzPqRAgXX6yw=s2048?key=pKn9UTVcy7kVo7f76IQZkQ

    4. Connect the Implement Pigtail Terminator to the T3H-S001 adapter and secure the terminator to the implement receiver wiring harness.

    image.png

     

    5. Connect the T3H-G002 adapter to the T3H-S001 adapter.

    image.png

    6. Connect the T3H-G002 adapter to the appropriate GNSS receiver port.

    7. If using NMEA 0183 Serial, also connect the NMEA extension harness to the T3H-G002, then connect the other end to the T3H-C002 ECU breakout harness.

    Verify:
    - Receiver powers on
    - GNSS data is being received by COMMAND

    Back to top