Skip to main content

John Deere StarFire

Harnessing Layout OverviewECU_JD_Starfire7000.png 

For use with COMMAND, the John Deere StarFire can be set up with typical John Deere implement harnessing:

  • Existing or aftermarket ISOBUS IBBC (Implement Bus Breakaway Connector) e.g. RE174726
  • BPF11284 - John Deere Front Extension Harness (10m)
  • PF90538 - John Deere Implement Receiver Wiring Harness Kit
  • PF81137 - John Deere Implement Pigtail Terminator Wiring Harness


image.png

Connection Processimage.png

    • Connect the John Deere Front Extension Harness to the IBBC route along the hosing/implement making sure to leave some slack wherever the hitch might flex but also paying close attention to any objects that could get caught on the harnessing.AGV_vUfkVZZq3AvV4_98cuYScitdZKiV-QrO04wsYPm-3GYiDJ5Auyt4g5Xk9ULGNpa_6Rr3K8pU7wOzOsF4TEge9Hpt5QVZ_KiGI30bt44WQf-cBH3KDsvhm3794BbM0oaVXo_k4WWtfg=s2048?key=pKn9UTVcy7kVo7f76IQZkQ

    image.png

    • Connect the Implement Receiver Wiring Harness to the Front Extension Harness and route the cabling up toward the receiver mast.

    image.png

      Connect the Implement Receiver Wiring Harness to the Starfire receiver 12-pin DT connector. A 12-pin Deutsch gender change adapter may be needed to connect the DT06-12SA connector on the implement receiver harness to the DT06-12SA connector on the StarFire Receiver.

      image.pngimage.png


        Connect the PF81137 Implement Pigtail Terminator to the Implement Receiver Wiring Harness and secure the terminator to the implement receiver wiring harness.
        Connect the

        image.png

        Implement Receiver Wiring Harness to the Starfire receiver 12-pin DT connector.

        Check that the receiver powers correctly and that its ISOBUS terminal appears correctly on the in-cab John Deere display.

        If not, refer to the troubleshooting section or contact us for assistance.
        Back to top