CNH AFS Direct Connect / PLM Intelligence

Tractor Connection

 

1. Following the connection of iGrade to the machine via the “Implement Interface” connector, the system then needs to
be configured on the armrest display.

2. Ensure that a new implement profile has been created for use with the scraper, or that the currently selected profile is
appropriate.

3. Open the “Remotes” settings tab to display remote valve configuration.

4. Set the desired remote valve outputs at the back of the tractor to the desired function (A or B).

 

Note: The remote valves selected for A and B should be matched to the valve connections at the back of the tractor pictured
below. We recommend setting auxiliary valve A to remote valve “Rear 1”, and setting auxiliary valve B to remote valve “Rear 2”,
which will configure remote valves 1 and 2 at the back of the tractor for use with iGrade.

5. Once the remote valves on the tractor have been set to the desired auxiliary function, the machine should now be fully
configured and ready for use. In order to engage auxiliary control, the user must ensure that the Auto Auxiliary Control
Valves A & B have been turned on in the relevant area on the “Remotes” page.

6. The “Auto Auxiliary Control Valve” can be accessed either by the hydraulic cylinder shortcut next to the display
navigation dial on the armrest, or by adding the menu to the display home page. Once this menu is accessed, turn
either or both required function to the on position and briefly push the lever until it clicks, similar to detenting a John
Deere tractor but the lever with not remain in place. Once both A and B lights are solid green, the tractor is ready to
accept 0-5V signals through the implement interface 6-pin connector.