John Deere Proprietary CAN

Interface Overview - John Deere Proprietary (JD CAN)

ForJohn Deere's transition to CANBUS-based SCV control systems occurred progressively across different models starting in the early 2000s. While exact transition years may vary by model series, tractors produced from 2005 onward are more information on configuring COMMAND for use with JD CAN SCVs, preferlikely to thefeature LevelCANBUS-based COMMANDSCV Manual.controls.

COMMAND's JD CAN valve interface interfaces with modern John Deere tractors by sending CANBUS messages to the integrated valve controller, commanding either port A or port B flow of the rear tractor SCVs.

COMMAND must be connected to the John Deere tractor ISOBUS and from that point, will be able to interface with the CANBUS operated SCVs. To operate the SCVs in automatic control mode, the user need to push the respective SCV lever into the detent position. This will cause "AUTO" to appear on the console/armrest to indicate that the SCV is ready for automatic control commands.

For more information on configuring COMMAND for use with JD CAN SCVs, prefer to the Level COMMAND Manual.