8.3 | Modern Case IH / New Holland / Trimble

This section covers connection of Novatel-based GNSS receivers using a 12-pin Deutsch interface. 
 Applicable to receivers including: Case IH - Vector Pro New Holland - PLM Cygnus Trimble - AG-372, AG-392, NAV-900 Steyr - S-Guide 
 
 Parts Required 
 
 BPF11284 - Front Extension Harness (10m) 
 PF81137 - Implement Pigtail Terminator Wiring Harness 
 T3H-G002 - COMMAND Impl Adapter - NAV-900 
 T3H-S001 - COMMAND Impl Adapter – Stub Junction 
 Optional - T3H-G001 / T3H-G007 - COMMAND NMEA Extension Harness
 
 Only required if using NMEA 0183 Serial for GNSS data. 
 
 
 
 Connection Process 
 1. Connect the John Deere Front Extension Harness to the ISOBUS breakaway connection. 
 2. Route along the implement, allowing slack at pivot points and avoiding snag hazards. 
 
 3. Connect the  T3H-S001 adapter to the Front Extension Harness. 
 
 4. Connect the Implement Pigtail Terminator to the  T3H-S001 adapter and secure the terminator to the implement receiver wiring harness. 
 
 
 5. Connect the  T3H-G002 adapter to the T3H-S001 adapter. 
 
 6. Connect the T3H-G002 adapter to the appropriate GNSS receiver port. 
 7. If using NMEA 0183 Serial, also connect the NMEA extension harness to the  T3H-G002 , then connect the other end to the T3H-C002 ECU breakout harness. 
 Verify: - Receiver powers on